Make sure you use the proper bit, not have it within a vise, make use of a hand drill, and go aspect by side (not all the way as a result of). three drills on both sides for a complete of 6.
Make sure to Adhere to the instructions straight from Polymer80. This is just how I did it for a couple frames.
Eric, with all owing respect, I think the LWD package is NOT a good idea for these, and would strongly advise Glock pieces. I have also created a few of them.
Additionally…the normal frame textured a single is a superb balance with the stock sample and stippling your self. Thanks to these factors…I have a a lot better, increased, plus much more constructive grip.
Do you think that they're going to at any time try this with other polymer pistols? I am not a big supporter of DAO triggers/striker fired. But i do such as this strategy.
This is often an great tutorial. I'm definitely carrying out this job. Many thanks for finding the time to publish this.
This model also encompasses a complete slide with front and rear serrations coupled with clean, fashionable traces along with a heavy entrance chamfer, permitting effective manipulation and holstering of the P80 pistol whilst protecting a lower-crucial aesthetic profile.
If you’re heading the milling route…load it up on your own vise but not too tricky. In any other case, get crackin’ on hand-filing everything!
for a few motive the cause on my g19 polymer would by no means reset. even immediately after grinding the metal piece down. i used an apex induce just like yours (in reality, its a grey p80 with a gray ghost stippled slide and pink apex result in... precisely like yours)
If you just can’t receive the pins to go through (Primarily about the rear polymer 1)…and you simply search as a result of to view obstructions. You are able to re-drill carefully.
Should you be using a employed slide It might be already put in. I used to be looking at a personalized slide plus the set up in the channel liner was a choice.
Then Get the slide lock…it’s not symmetrical so make sure you can begin to see the side While using the “tooth” and have it face the rear. Don’t mess this up as it catches the barrel lug (aka keeps your barrel/slide from traveling off).
I would counsel carrying out it fully by hand…or beginning it off using a Dremel in addition to a grinding attachment.
I've had to dissembled the frame 2 times to offer images past their regular asked for photographs. Assistance statements which i failed to deliver shots they asked for.. I've even had e-mails turned down from polymer80. And Polymer80 is still pictures over and click here above their Generally requested images for an apparent broken frame.